Says "cant connect to external drive" after update

[kitsboy]

I tried to login from local and my I.P…I keep getting this error. I did not change it from before the update.

Im in the bottom right port, closest to the eth cable.

Im just getting a red light on my pi. Not sure where to go from here, I tried to restart a few times, no luck.

Any suggestions??

[kitsboy]

[dertize]

Hey there. Had the same issue.
This helped: Umbrel Troubleshooting Guide

@DarthCoin

My external disk drive is not mounting, what can I do?

If you detect that your disk drive is not recognized, is blacklisted, is not accessible, enter SSH and run de debug logs:

~/umbrel/scripts/debug --upload

At the end of the log you will obtain a link where the log was uploaded. Open it and see the lines about your USB drive (" External storage service logs" section).

If you see:

Blacklisting USB device IDs against UAS driver...

USB devices weren't registered after 10 tries...

then, try this command using SSH access:

sed -i 's/ blacklist_uas/ #blacklist_uas/g' /home/umbrel/umbrel/scripts/umbrel-os/external-storage/mount && sudo reboot

After that, check again your USB cabling connection and restart normally your node. Wait until the node is catching up with the blocks, it will take a while, be patient.

Hope you back back and running.
Cheers

[kitsboy]

@DarthCoin

sed -i 's/ blacklist_uas/ #blacklist_uas/g' /home/umbrel/umbrel/scripts/umbrel-os/external-storage/mount && sudo reboot

Ohhh wow…you TOTALLy saved me! I am nervous about my terminal usage…but you gave me the perfect directions, thank you so very much!!

All fixed back up and running!