Hi, I installed everything for the raspberry pi using Umbrel. I’m getting this screen when wanting to setup Umbrel in the registration setup pages. Does this take a while? I’ve been rebooting and reinstalling the software as well and it keeps doing this.
Any suggestions?
It takes a while around …5 minutes
Are you using the same specific hardware requested for the rpi4? 1TB ssd?
Yes, rpi 4 8Gb 1tb SSD etc
I’ve been waiting about 8 hours now, still no progress for some reason.
I would try reflashing umbrel OS to the sd card.
Same here…
RasPi 4B 4GB 1TB SSD 16GB Card
Flashed already for the second time.
try formating the SD card to ext4 before reflashing.
the raspi is up and running. I can login via ssh but the webserver is showing only the start screen as above…
bevore there was a message that the storage got disconnected.
I changed the powersupply
I am using an mSATA SSD 1TB with USB 3 adapter
Device Boot Start End Sectors Size Id Type
/dev/mmcblk0p1 8192 532479 524288 256M c W95 FAT32 (LBA)
/dev/mmcblk0p2 532480 31211519 30679040 14.6G 83 Linux
Disk /dev/sda: 953.9 GiB, 1024209543168 bytes, 2000409264 sectors
Disk model: 2235
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes
Disklabel type: gpt
Disk identifier: 553B4962-4BC9-433A-96FC-059F82ECED10
