I upgraded to 0.4.6 about 6 hours ago and my node has not been working since. I’ve restarted a few times but I am stuck. Bitcoin Core says 100% but also says last block was 6 hours ago. [image]

I am spinning up a brand new node … All new hardware and it doesn’t seem to be syncing at ALL… Only been about 20 minutes but zero blocks have synced

same issue with me since yesterday. My bitcoind logs are filled with ThreadRPCServer incorrect password attempt from 10.21.21.9 which is LND’s container IP. LND’s logs are filled with wallet locked, unlock it to enable full RPC access. I’ve logged into the LND container and ran lncli unlock and it …

I also have the same issue. My node is in perpetual sync mode with both wallets. Flashed the micro sd, but that failed to fix anything. I upgraded to 0.4.6 too. Before this happened, I went into ssh to change my alias, so that might be the problem also. Anyway, do I need to re-initialize my ssd …

I am starting from scratch and spinning a node with new hardware using my seed phrase :crossed_fingers:

Check out this previous thread. Stuck at "deleting previous images" updating 0.4.5

So I got an “official” raspberry pi power supply and it helped a little… the dashboard now shows my BTC and lightning balances and starts syncing the blockchain and gets as close as 30-50 blocks to being current but then restarts at the same place from about 2 days ago when I upgraded. Also I am no…

I have been in this for about 4-5 days now. I am just stuck in a syncing loop. It starts on a block about 5 days ago (when I upgraded to 4.6) and gets to about 20 blocks from the current block and then starts over again… I just tried a manual update to 4.6 using SSH but that didn’t seem to matter …

I gave up trying to save my previous node instance. Next, I re-flashed Umbrel OS with the same SSD which is 100% synced and entered my 24 words, but still my sats did not show up. I tried re-indexing bitcoind without success. My next step, I flashed a fresh Umbrel image again and started with a sep…

Node stuck since upgrade to 0.4.6

Support and Troubleshooting

xstaffquick October 31, 2021, 4:24pm 6

@NoBS and do you get it up and running?

1 Like

Topic		Replies	Views
Bitcoin Core stuck at Synchronizing in 0.4.4 Support and Troubleshooting	3	822	December 12, 2021
Several Weeks Waiting on Wallet Synchronizing -- Bitcoin Core at 100% Support and Troubleshooting	4	848	December 12, 2021
Umbrel stuck synchronising, after 0.4.9 upgrade Support and Troubleshooting	15	2201	February 24, 2022
Node Stuck at Syncing w/ 1 peer for 6 days - RPI4 w/ Ethernet connection- and flashed and updated sd card Support and Troubleshooting	3	1529	December 7, 2021
I can't connect to LND after the update Support and Troubleshooting	27	1362	March 24, 2024

Node stuck since upgrade to 0.4.6

Related topics