Just got my Umbrel home but login fails

:warning: Here is a step-by-step guide to fully resetting an Umbrel Home:


  1. Initiate the Factory Reset: Open a terminal and run the following command to reset Umbrel Home:

    curl -L https://link.umbrel.com/factory-reset | bash
    
  2. Prepare the Reflasher USB Stick: Use BalenaEtcher to flash the Umbrel-USB-Reflasher image onto a USB stick.

  3. Power Off Umbrel Home: Turn off Umbrel Home at the power switch.

  4. Insert the Reflasher USB Stick: Plug the USB stick into Umbrel Home.

  5. Turn Umbrel Home Back On: Power on Umbrel Home with the USB stick inserted.

  6. Wait for Reflashing: Allow about 5 minutes for Umbrel to automatically reflash its internal SSD. Umbrel Home will power off when the reflashing process is complete.

  7. Remove the USB Stick: After Umbrel powers down, remove the USB stick.

  8. Turn Umbrel Home On Again: Power up Umbrel Home once more.

  9. Wait for the Initial Boot: Umbrel will complete its first boot, which can take around 5 minutes.

  10. Complete Setup: Once booted, go to http://umbrel.local in a web browser and follow the on-screen setup instructions.


After completing these steps, any available updates should appear and install without any issues.