Upgrade to UmbrelOS 1.4.2 - 1.5 not working

Support and Troubleshooting
1

I can perform the upgrade but after the reboot am back into UmbrelOS 1.4.2. Am running on Raspberry Pi 4 with 4GB Memory.

SOLUTION:

Just found solution that worked for me here. I can't update umbrel from 1.4 to 1.4.2 šŸ˜¢ - #8 by swizly12

Just replaced 1.4.2 with 1.5.0 in the command and it worked for me, am now on 1.5

2

I have the same issue on a Rpi 5 with 8GB Ram, the update is never happening. It gets stuck at ā€œRestarting pageā€, until I unplug the Rpi, and I am back to 1.4.2

Can someone support, please?

3

Here to report Iā€™m experiencing the same issue on my Pi 5 8GB. Iā€™m glad Iā€™m not the only one. Looking forward to hearing from the Umbrel team about a potential fix.

4

Same here - I have 1.4.2 on a Intel NUC (Model NUC10i7FNH) and when I click ā€œInstall Nowā€, the progress bar works, but when it says ā€œRestartingā€ it hangs. I let it sit for two hours just to make sure, but finally I turned off my NUC and when I turned it back on, itā€™s still on 1.4.2. I tried this twice with the same result.

5

I have a Raspberry Pi 4 - 8 GB and the update was successful and everything seems to be working fine.

6

Those Pi4 8GB seem to be the stuff. I know when I ran one, it was unstoppable but slow. Iā€™m glad to read they are still rocking.

7

Wondering if money is the same type of issue. Its a pi5 with 8gb. Trying to download a btc node on btc knots, and its keeps getting stuck syncing. Reset, then its fine for a while.

8

SOLUTION:

Just found solution that worked for me here. I can't update umbrel from 1.4 to 1.4.2 šŸ˜¢ - #8 by swizly12

Just replaced 1.4.2 with 1.5.0 in the command and it worked for me, am now on 1.5

9

An additional note for anyone that still cannot run this update even with the command: You can still just install the update manually by removing the SD card from the Pi, plug it into your computer, and install the latest version using Etcher.

Thatā€™s what I ended up doing because nothing else worked for me. Thankfully I had Umbrel OS installed separately from my external SSD storage so everything came back online with no issue after manually installing the OS using Etcher.

1 Like