Hello! I followed the instructions and after seeing the raspberry pi 4 running after kick off it stops here: Debian GNU/Linux 10 umbrel tty1 umbrel login: My keyboard and mouse are set up too but I can not type anything (not that I’d know what to type) maybe its the SSD i have not downloaded any…

I removed everything from the Pi maybe I need to restart it but again the ip address is not being recognized

i figured it out it was because I had the network cable direct to the modem and not to the router which the laptop is on wifi network…now its up and asking me for my name and password and seed phrases…think I’m doing it right finally!

There was also a problem for me that I entered from the introduced IP and it was not a problem

Umbrel Setup - First Time Node builder

Support and Troubleshooting

DarthCoin March 20, 2022, 12:24pm 7

In the Guides section of this forum I wrote an extensive guide about how to set a static IP for your node. I strongly recommend reading it.

Topic		Replies	Views
Initial Setup Issues Support and Troubleshooting	1	566	July 28, 2021
Unable to access Umbrel.local Support and Troubleshooting	8	42767	April 30, 2022
Newbie Node help General Discussion	6	1182	September 14, 2021
Fresh install isn't findable on my network, and can't login via terminal either Support and Troubleshooting	4	2497	September 11, 2023
Connection to umbrel lost, hardware troubleshooting Raspberry Pi Support and Troubleshooting	2	597	April 24, 2022

Umbrel Setup - First Time Node builder

Related topics