Umbrel.local login problem

[btc1]

HW Pi3 4GB - 16GB Micro SD and 2TB HD

Installation sucessful - I can see the login on the command line … and every check was “ok”
but when I go to the browser and open umbrel.local I just see the following picture (attached) Raspberry is in the same network range and there is nothing which can block the request.

Was waiting for hours - but still the same status

Any ideas?

[mc639]

I would try using the USB 3.0 port on the pi if available, my node didn’t work until I used the USB 3.0 to connect my SSD. Not sure if this will help in your case.