# Umbrel.local login problem

**URL:** <https://community.umbrel.com/t/umbrel-local-login-problem/2155>\
**Category:** Support and Troubleshooting\
**Created:** [July 25, 2021, 8:53pm UTC](https://community.umbrel.com/t/umbrel-local-login-problem/2155 "2021-07-25T20:53:02Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![btc1](https://avatars.discourse-cdn.com/v4/letter/b/9d8465/32.png) [@btc1](https://community.umbrel.com/u/btc1)\
**Post date:** [July 25, 2021, 8:53pm UTC](https://community.umbrel.com/t/umbrel-local-login-problem/2155/1 "2021-07-25T20:53:02Z")

</div>

HW Pi3 4GB - 16GB Micro SD and 2TB HD

Installation sucessful - I can see the login on the command line … and every check was “ok”  
but when I go to the browser and open umbrel.local I just see the following picture (attached) Raspberry is in the same network range and there is nothing which can block the request.

Was waiting for hours - but still the same status

Any ideas?

![Bildschirmfoto 2021-07-25 um 22.27.14](https://canada1.discourse-cdn.com/flex030/uploads/getumbrel/original/1X/571fcedd1e2625a132da55c4dd29a2830c91900b.png)

---

<div class="post-metadata">

**Author:** ![mc639](https://avatars.discourse-cdn.com/v4/letter/m/a9a28c/32.png) [@mc639](https://community.umbrel.com/u/mc639)\
**Post date:** [July 25, 2021, 10:32pm UTC](https://community.umbrel.com/t/umbrel-local-login-problem/2155/2 "2021-07-25T22:32:01Z")

</div>

I would try using the USB 3.0 port on the pi if available, my node didn’t work until I used the USB 3.0 to connect my SSD. Not sure if this will help in your case.