# Manual update to 0.3.10 issue \[solved\] **URL:** \ **Category:** Support and Troubleshooting\ **Created:** [May 11, 2021, 1:56pm UTC](https://community.umbrel.com/t/manual-update-to-0-3-10-issue-solved/821 "2021-05-11T13:56:29Z")\ **Posts on this page:** 2\ **Page:** 1
**Author:** ![mirluin](https://yyz2.discourse-cdn.com/flex030/user_avatar/community.umbrel.com/mirluin/32/181_2.png) [@mirluin](https://community.umbrel.com/u/mirluin)\ **Post date:** [May 11, 2021, 1:56pm UTC](https://community.umbrel.com/t/manual-update-to-0-3-10-issue-solved/821/1 "2021-05-11T13:56:29Z")
After dozens of failed attempts from the UI (all ending stuck on the “Starting update…”) I decided to try updating manually my Umbrel to 0.3.10, following the instructions provided in the FAQs. Everything seemed to go well (see the related [Pastebin](https://pastebin.com/CTzZGwVU)) but then I couldn’t access anymore my node (“Unable to connect” error), nor by IP, nor via umbrel.local or onion address. After a few attempts, to my surprise, I noticed that meanwhile, the update process somehow started also in another browser tab where the Umbrel UI was previously open (from a previous update attempt), but it’s stuck on “Removing old containers…”. It’s been like this for half an hour, what should I do? Thanks in advance for your help! ---
**Author:** ![mirluin](https://yyz2.discourse-cdn.com/flex030/user_avatar/community.umbrel.com/mirluin/32/181_2.png) [@mirluin](https://community.umbrel.com/u/mirluin)\ **Post date:** [May 11, 2021, 3:38pm UTC](https://community.umbrel.com/t/manual-update-to-0-3-10-issue-solved/821/2 "2021-05-11T15:38:53Z")
I decided to try what suggested in [this thread](http://community.umbrel.com/t/cannot-update-from-0-3-8-despite-completing-update-process/287/5) and, after re-running the manual update and rebooting via SSH, I was able to reach again for my node. Everything seems ok! 🤗