# BTC Node, Lightning and Electrs all not working **URL:** \ **Category:** Support and Troubleshooting\ **Created:** [September 27, 2022, 4:09pm UTC](https://community.umbrel.com/t/btc-node-lightning-and-electrs-all-not-working/9615 "2022-09-27T16:09:44Z")\ **Posts on this page:** 1\ **Showing post:** 7
**Author:** ![LVONM](https://avatars.discourse-cdn.com/v4/letter/l/a9adbd/32.png) [@LVONM](https://community.umbrel.com/u/LVONM)\ **Post date:** [October 12, 2022, 6:29pm UTC](https://community.umbrel.com/t/btc-node-lightning-and-electrs-all-not-working/9615/7 "2022-10-12T18:29:40Z")
Hi VillatraxETH, If you can access your local network via VPN (Tailscale _might_ work too although I can’t confirm) then you should have no problem using an SSH client to log into your Umbrel remotely. You should have no problem using Powershell or alternatively you can download PuTTY. See the second item in this guide and note that if you use Poweshell, the command to login into your Umbrel is slightly different than conventional SSH clients such as Putty or ones built into Unix/Linux systems. > [@Umbrel Troubleshooting Guide](http://community.umbrel.com/t/umbrel-troubleshooting-guide/3632): > > Edit by moderators The new, official troubleshooting guide can be found here: Huge thanks to DarthCoin for writing and maintaining the previous community version of the guide. After a successful login then all you should have to type to delete the peers.dat file is ` sudo rm ~/umbrel/app-data/bitcoin/data/bitcoin/peers.dat` Followed by the password again. The general advice is to wait about 24 hours. My Umbrel was back in operation within far less time but YMMV. --- _[View the full topic](https://community.umbrel.com/t/btc-node-lightning-and-electrs-all-not-working/9615)._